Jayco GRANITE RIDGE, Руководство пользователя

Страница: 45 / 134

Bath and Shower
Your bathroom facilities function similar to those in your home. Prepare your bath or shower
curtains to prevent water from spilling onto the floor. Be sure the water heater is in operation before
bathing. Adjust the faucets for desired temperature before entering the tub or shower. The shower
heads are equipped with a vacuum breaker to prevent pressure buildup. This valve allows water to
bleed out. Turn the water off at the tub/shower faucet, not the shower head.
Used water will drain through the plumbing pipes in the gray water holding tank. Remember your
capacities of water heater and gray water holding tanks. Long showers in a recreation vehicle are not
suggested due to the amount of water that is available. To conserve water, wet down, and turn water
off while you use soap, then rinse.
Draining
NON-BASEMENT MODELS
1. Open all faucets including the exterior shower (if applicable).
2. Open the fresh water tankdrain.
3. Open valves 1, 2, 3 and 5 and close valves 4 and 6. (Fig. 4-12 & 4-13 or 4-14)
4. Open the water heater drain.
5. Open the toilet valve, hold or blockif necessary.
6. To empty the pump, start and allow to run 20 seconds.
FULL BASEMENT MODELS
To drain the permanent fresh water tankon full basement models, open the
tanklow point drain valves in the utility center. (Fig. 4-15 & 4-16)
The Systems 37
Non-Utility
Center
Fig. 4-16
Fig. 4-15
Utility Center