Jayco 2016 JAY FLIGHT, Руководство пользователя

Страница: 66 / 136

SECTION 6 - ELECTRICALSYSTEM JAYCO CAMPING TRAILERS
6-8 30 AMP
T
ESTING THE
C
AMPSITE
P
OWER
C
ONNECTION
The campsite 120-volt power receptacle(s) should always be tested for proper
functionality prior to plugging the RV shore power cord into it. DO NOT plug the
RV shore power cord into a campsite receptacle(s) that has reverse polarity,
non-functioning ground circuits, or that shows outward signs of heat damage.
Injury or damage resulting from connection to malfunctioning or improperly wired
power sources is
not covered by your RV warranty.
Campsite 120-volt power receptacles can be tested using a digital multimeter or a
dedicated circuit analyzer. Dedicated circuit analyzers plug directly into the
campsite 30-amp power receptacle and minimally test for open neutral, open
ground, and correct polarity.
Connecting the RV shore power cord:
1. Test the campsite electrical box or receptacle for proper power.
2. Turn “off” the Load Center 120-volt circuit breakers.
3. Carefully extend the entire length of the power cord (approximately 25’-35’)
from the electric cable hatch to the external power source.
DO NOT COIL UP THE SHORE POWER CORD
4. Plug the power cord into the receptacle (if the receptacle tests ok). Be sure all
the power cord prongs are properly plugged into the receptacle.
5. Return to your RV and turn “ON” the Load Center 120-volt circuit breakers.
6. To help prevent power surges from damaging the connected loads, please
follow these instructions when hooking up to the external power source:
WARNING
PLUG INTO 30-AMP SERVICE ONLY .

Do not hook up the 30-amp power cord to any receptacle until you have
verified proper polarity and grounding. RV circuit analyzers can be
purchased in most electrical or hardware stores.

Do not use any cheater plug, adapter or extension cord to reduce
incoming AC power or break the continuity of the circuit connected to the
grounding pin.

Do not connect the power cord into an outlet that is not grounded, or
adapt the 30 amp power cord plug to connect it to a receptacle for which
it is not designed.

Do not remove the grounding pin to connect to a non-grounded
receptacle. Removal of the ground pin disables an important safety
feature designed to prevent shock and electrocution hazards.

Do not connect the power cord to an extension cord. Use of an improper
extension cord will cause overheating of the cord as well as potentially
causing premature failure of the AC equipment.
It is the responsibility of the owner of the electrical receptacle to ensure that
the receptacle is properly wired and grounded. Reverse polarity and/or
improper grounding of your RV can cause personal injury or death.