Jayco 2016 JAY FLIGHT, Руководство пользователя, Страница: 127 / 136

JAYCO HARD WALL MODELS SECTION 14 – SETUP & MAINTENANCE
SCT HS 14-13
Step 7 (Cont’d)
Inside the room on the upper sidewall, there will be two sleeves with a gap in the
middle. Insert the Side Roof Pole (ball end) into the sleeve that feeds back
towards the trailer. (Refer to the middle photos on the previous page) Plug the
ball into the socket attached to the fabric pad as shown. Loosen the clamp to
allow the claw end to slide, and feed it into the other sleeve. Extend the claw end
up to the Arch Pole in the front corner and attach the claw to Arch Pole between
the 2 rivets. Repeat procedure for the other side.
When all of the support poles have been installed, the screen room should look
like the two photos below.
Step 8
Seal the exterior corners where the screen room meets the trailer (below the 30”
Velcro strips front and rear). The screen netting along bottom of the trailer will
attach to the Velcro sewn into the screen room fabric at these corners as shown
below.
Step 9
The sidewalls and front wall should be anchored to the ground using the supplied
tent stakes. The stakes should be hooked into the elastic cord loops attached to
the bottom of the walls. The walls should be pulled taught and then the stakes
driven into the ground. The vertical sidewall poles, on each front corner, have
loops on them at the bottom and should be staked in place also.
screen netting Seal lower corner