These are the mains power (240V) cables. Ensure that the printer is not plugged in to
mains power, and that the main power switch is in the off position. Firstly take the
three long wires, and tilt up the protective barrier on the power supply. Loosen the
three left screws on the power supply, then insert the tinned cable ends and screw
down firmly. Ensure the red wire goes into the connection marked ‘L’ (live), the black
wire goes into the ‘N’ (neutral), and the green and yellow wire goes into the ‘
’
(earth). Then thread the wires out to the top of the printer through the top plate.
Then feed the wires into the base through the side shield and attach the crimp ends of
the red and black wires to the switch side of the power socket module, and the green
and yellow wire to the power socket. The two short wires go between the switch and
power socket. From left to right, the wires are green and yellow, black, red, red, black.
The red and black wires going to the top of the printer are closest to the camera.
