5. Remote Control Setup
Slide open the battery cover
in the indicated direction
Remote Control
Battery Cover
Use 6 x AA batteries and insert them in the
polarity shown. Do not mix batteries of
different type.
Use the supplied USB cable and charger to charge the Li-polymer Battery
Plug the USB cable into the computer’s USB
socket, then plug the other end into the
supplied charger. Plug the Li-polymer battery
into the charging socket.
Red LED light indicates the
battery is charging.
The red LED light turns off
when charging is complete.
Take off from throwing
1. Do NOT throw upward
2. Throw horizontally
3. Do NOT throw downward
After the pairing, make sure both the rudder and elevator
are in neutral (middle) position.
Push the throttle stick to about 60%. Face the wind and throw
the plane horizontally. Immediately pull the direction button
down a little to lift the plane.
Prepare for landing immediately when the plane starts to become
underpowered. Turn the plane around so it faces the wind, and then
decreases throtlle to slow down the speed. The plane starts to
slowly glide towards the ground. Reduce the throttle to zero when
the plane touches ground. Adjust the elevator as necessary when
touching down.
During gliding, adjust the rudder to keep straight.
aeroplane
If the remote control is not
used for a long time, please
remove the batteries.
Turn Off the Remote Control
If the remote control is not
used for a long time, please
remove the batteries.
