Jaycar Electronics LA-9011, Руководство пользователя

Страница: 4 / 16

GREEN LED ON continuously :GSM searching networks
GREEN LED OFF continuously :Power off
GREEN LED Flashes fast :Incoming call or sending an SMS
RED LED Flashes once :Uploading current tracking
RED LED Flashes twice :Can not upload tracking now
4. Recharging & Power Supply
Warning: this tracker is powered by 9-28VDC, high AC or DC voltage may damage the unit, so please check the
power supply first before installation.
For use in a vehicle, it is necessary to connect the tracker to the car battery all of the time, after the back up battery
is full, the built in recharging circuit will stop recharging. If the tracker is not moving, then the tracker will go into
sleep mode to save power draining from the car battery.
Wiring
RED----------12V/24Vcar battery
BLACK------GND (Car Body)
YELLOW----Cut Relay Driving (Immobilizer Control)
WHITE-------External SOS button
5. Restoring To Default (Factory Configuration)
Power off the tracker first, press the “ON/OFF” button and don’t release (remove the battery and place it in the
tracker or connect the power wire to the car battery) to power automatically. A few seconds later the GREEN LED
will flash 10 times and turn ON continuously, Then release the “ON/OFF” button. The tracker is now set to default
configuration.
Notes: After default has been set, all IP / APN / GPRS / TIME ZONE settings are reverted back
to default, all preset phone numbers are deleted and the password is changed to 123456. All the
alarm settings are cancelled, if the IP/APN/GPRS name& password/TIMEZONE are changed. You
need to set these again by sending an SMS.
6. Antenna
The Antenna of GSM and GPS are built in to the tracker.
Please position the tracker away from metals, as this may reduce the GSM and GPS signal.
7. Shock Sensor Control GPS ON/OFF & Power Saving
This tracker has a built in shock sensor, default is SHOCKCONTROL mode. When the tracker begins to move the
tracker will turn on GPS and upload the location automatically, when the tracker stops moving 2 minutes, the
tracker will turn off GPS & GPRS automatically (Stop uploading location).
8. Working Conditions
The working temperature is -20
0
C to 60
0
C, over this range the tracker may not function correctly.