Jay-Lor 2875, Руководство оператора

Страница: 23 / 53

JAY
•
LOR ®
Operator’s Manual - 21 - Trailer Units - Models 2875 - 21000
C. After operating for 5 hours and 10 hours:
•
Retorque all wheel nuts, fasteners, and hardware.
•
Check that auger turns freely.
•
Check the auger. Remove all string, twine, or other entangled material.
•
Proceed with normal servicing and maintenance schedule as defined in the
Maintenance Section.
EQUIPMENT MATCHING
The machine is designed to be used with Agricultural tractors. To ensure a good
performance, the following list of specifications must be met:
1. Horsepower:
The minimum horsepower that is required for a JAY
•
LOR
®
Model 2875 Cutter-Mixer-
Feeder is 120HP with a 2-speed transmission or 150HP without a 2-speed
transmission. The minimum horsepower that is required for a JAY
•
LOR
®
Model 21000
Cutter-Mixer-Feeder is 130HP wih a 2-speed transmission or 160HP without a 2-
speed transmission.
2. PTO Shaft:
The tractor PTO Shaft must meet the following specifications:
1000 RPM – 21-spline, 1-3/8” diameter
or
1000 RPM – 20-spline, 1-3/4” diameter
Important: It is not recommended that shaft adaptors be used on the tractor shaft to
prevent operating at the wrong RPM.
3. Drawbar
Dimensions:
The tractor drawbar dimension
must be
16 inches between
the end of the shaft and
drawbar pin hole center for
1000 RPM units equipped with
a 1-3/8” diameter PTO Shaft.
The tractor drawbar dimension
must be
20 inches between
the end of the shaft and
drawbar pin hole center for
1000 RPM units equipped with
a 1-3/4”diameter PTO Shaft.
Figure 3 - Drawbar Setting.
DRAWBAR
TRACTOR
PTO