JAWA Dandy MJ50, Руководство по эксплуатации и обслуживанию

Страница: 17 / 32

8.1. Lubrication and Maintenance Schedule
Work Description and Scope
Before
Putting
into
Operation
After
every
1,000 km
3,000 km 6,000 km
In Case of
Need
Screws and nuts
Tighten all screws and nuts (See Section 8.2.)
x x
Driving chain
Check tightening of the chain. Clean and grease it by
the spray for chains. (See Section 8.17. & 8.18. ) x
Brake adjustment
Brake lining - Check the brake lining.
(take care of minimum thickness of the lining) x
When the brakes work incorrectly, check the
function of hand/foot brake and make required
adjustment. Grease joints and cables.
x
Replace worn out, mechanically damaged or
oiled lining.
x
Brake fluid
Check of the state of the break fluid and its
replacement, if need be. (See Section 8.12_, 8.13)
x
Every
x
2 years
Rear wheel swinging fork
Check its bearing - without clearances
x
Gear oil
Check the amount of oil and refill it, if need be
x
Oil Replacement
400 ccm of gear oil (See Section 8.4., 8.5.)
x
Sparking plug
Check of the electrodes spacing and overall condition
of the plug. Replace it, if need be. (See Section 8.9.) x x
Exhaust silencer and paper filter
Clean the intake paper filter. Replace it, when to
dirty. (See Section 8.7.) x x
Speedometer drive
Grease the speedometer drive (on the wheel axis)
SHELL RETLNAX-A x
Bowden cables
Lubncate the cables with thin oil
x
Fuel screen in the carburetter
Clean the fuel screen by petrol and blow it through by
pressure air. In case of damage replace by a new one. x x
Fuel cock
Clean the fuel cock screen and blow it through by
pressure air. (See Section 8.6.) x
Carburetter
Clean individual parts of the carburetter
(See Section 8.6.) x x
Exhaust silencer decarbonization
Remove the oil carbon from the exhaust piping end.
(See Section 8.25.) x
Ignition check
Have the check made in a special service.
(See Section 3.10.) x
16