User Manual Javo Rotofill
Version 2014-1-2
13
5.7
Check substrate retour chain tension
Check the substrate retour chain tension before you start working with the machine.
Procedure:
1.
Check the substrate retour chain tension. The correct tension is obtained when the chain is reaching the
bottom plate in the middle.
2.
Adjust the chain tension if necessary .
5.8
Set substrate conveyor speed
Set the substrate conveyor speed before you start working with the
machine.
Procedure:
1.
Check the substrate conveyor speed. Set the speed in this way that trays
are being filled sufficiently before they reach the substrate slide.
2.
When the speed needs to be adjusted:
a.
Loosen locking bar (A).
b.
Turn wheel (B):
i.
CCW = substrate conveyor will run slower.
ii.
Clockwise = the speed of the conveyor is increased.
c.
Tighten locking bar (A).
5.9
Set compactor height
Set the compactor height before you start working with the machine.
Procedure:
1.
Check the compactor height with respect to the tray.
The compactor should not touch the tray. There should be a gap of
about 10mm.
2.
If the height is incorrect:
a.
Loosen clamp (A).
b.
Turn the compactor to the desired height with crank (B).
i.
The lower the compactor is over the tray, the harder the ground tension will be.
ii.
The higher the compactor is over the tray the softer the ground tension will be.
c.
Tighten clamp (A).
