Javad HPT404BT JL, Руководство оператора

Страница: 41 / 56

Command Line Interface
GSM
41 www.javad.com
Note:
The internet service can be configured in its stopped/disconnected state only.
Note:
The RTN command is case sensitive to support possible case sensitive string type values of its parameters.
7. GSM
GSM command is used to configure, control and monitor the built in Quad band GSM/GPRS module.
ERROR Gets the description of last error occurred in the active RTN service. This parameter is
used for monitoring purposes.
Example: next command gets the last error occurred in the active RTN service
RTN ERROR
None
AUTORUN Sets/gets the auto running state of the RTN service.
0 – Disables auto running of active RTN service for next boots;
1 – Enables auto running of active RTN service for next boots.
To take effect the parameter should be saved in the configuration file using SAVE
command.
Parameter name Parameter list and description
BAND Sets/gets the operating frequency band of GSM/GPRS module:
0 - GSM 900MHz, DCS 1800MHz;
1 - GSM 900MHz, PCS 1900MHz;
2 - GSM 850MHz, DCS 1800MHz;
3 - GSM 850MHz, PCS 1900MHz.
Example: next command sets the operating frequency band of GSM/GPRS module to “GSM
900MHz, DCS 1800MHz”.
GSM BAND 0
Next command gets the current operating frequency band of GSM/GPRS module:
GSM BAND
GSM 900MHz, DCS 1800MHz
@00
RSSI Gets the received signal level of GSM/GPRS module which is used for monitoring purposes.
<response> – N/A – the GSM/GPRS module switched OFF or signal quality is not recognized;
Not known – the received signal level of GSM/GPRS module is not detected yet;
Value of received signal level in dBm.
Example: next command gets the current received signal level of GSM/GPRS module.
GSM RSSI
-79 dBm
@00
PINCODE Sets/gets the string type value representing the PIN code of the SIM card installed. PIN code is
used by firmware to unlock the SIM card if it is requested. Otherwise the parameter is ignored.
<value> - string (length < 64 bytes).
Example: next command sets the PIN code to “1111” to unlock the SIM card by firmware.
GSM PINCODE 1111
Next command gets the currently set PINCODE parameter:
GSM PINCODE
1111
@00