Javad Beacon, Руководство пользователя

Страница: 12 / 19

12 www.javad.com
COMMAND LINE INTERFACE
The built-in user-friendly Command Line Interface (CLI) allows user to perform a full configuration of
the unit and read the statistics and alarm status. It is the most powerful tool to configure the unit. It makes
changes to all possible settings that system will not be able to determine automatically.
The CLI commands allow user to configure and reconfigure the unit’s settings. The user configuration
parameters that could be changed through the CLI are:
• Data Port Settings
- Baud Rate
- Flow control (None or RTS/CTS)
- Stop bits
• Alarm Settings1
• Radio operation modes
• Scanning modes
• Sleep modes2
- On/Off
- Activate by internal real-time clock
- Activate through RTS/CTS lines
- Activate by external sense lines
- Activate by any combination of the parameters mentioned before
Note:
The unit’s configuration that is set or modified through the CLI will be lost after unit’s reboot, unless the
saving operation is used to store a new setting in the unit’s configuration file.
The CLI commands also provide filing operations, which include:
• Downloading
- Unit’s Configuration files
- Software Images
• Uploading Unit’s Configuration files
• Saving into the configuration files the configuration parameters modified through the CLI.
Command Line Interface Convention
The following convention is implemented in Beacon Receiver Command Line Interface (CLI):
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a command delimiter.
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a reply delimiter followed by the “CLI>”
• prompt if Echo option is On.
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a reply delimiter if Echo option is Off
• (default option).
• The 2-digit number followed by “@” in the unit’s reply indicates the error code (refer to Table 3-
• 1 for description).
• A successfully performed command is replied by @00 code for both Echo ON and OFF modes.
• A command with the certain
[Parameter Name]
and blank
[Parameter List]
displays the current
settings for a given parameter.
• To set the mode ordered by CLI commands as permanent User Setting (the setting automatically selected