maintenance instructions
Models EBS--1
page 10 of 12
JARVIS
6205012:.
®
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL.
TEL. 860--347--7271 FAX. 860--347--6978 WWW. j
arvisproducts.com
7.13 Remove stator (item 27).
7.14 Press bearing (item 31) out of main housing
(item 28).
7.15 Inspect all parts for wear and replace if neces-
sary.
8 MOTOR ASSEMBLY:
8.1 Reverse steps and procedures outlined in section
7.
See special notes below
:
8.1.1 Apply either
Loctite 271
or
Loctite 262
thread locking compound to crank (item 33)
and hex jam nut (item 34).
8.1.2 Check direction of motor.
Refer to Installa-
tion Instructions, step 2.7 on page 7.
8.1.3 Make sure beveled retaining ring (item 32)
is correctly installed.
Refer to Figure 3.
Figure 3
Correct position
of beveled
retaining ring.
Bearing
Rotor Shaft
9 REAR HANDLE DISASSEMBLY:
9.1 Remove oval head screws (item 45).
9.2 Remove rear handle bracket (item 62).
9.3 Remove screws (items 53 or 69).
9.4 Remove cover (item 56 or 68) and gasket (item
58 or 67).
9.5 Loosen screws (item 51 or 69) on switch (item
50 or 73) to disconnect power cord (item 54 or
71) and motor lead wires.
9.6 Remove four (4) cheese head screws (item 59).
9.7 Pull away rear handle (item 61 or 75) enough to
remove ground screw (item 59) fastening
ground lug to main housing (item 28).
9.8 Remove cheese head screws (item 51 or 66) and
switch holding clamp (item 52) and lift switch
(item 50 or 73) from rear handle (item 61 or 75).
9.9 Remove trigger bushing (item 48) and plunger
(item 49 or 74).
9.10 Inspect all parts for wear and replace if neces-
sary.
9.11 Remove gasket (item 30).
10 REAR HANDLE ASSEMBLY:
10.1 Reverse steps and procedures outlined in section
9.
See special note below
:
10.1.1 Make sure to install gasket (item 30) before
connecting power cord wires (item 54 or 71)
to switch (item 50 or 73) and installing cov-
er (item 56 or 68).
10.2 Check direction of motor.
Refer to Installation
Instructions, step 2.7 on page 7.
