page 11 of 12
MODEL 444
®
JARVIS
6205004;:.
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA E--MAIL.
FAX. 860-347-6978 TEL. 860--347--7271 WWW.
jarvisproducts.com
8 Screw in each of (3) set screws (items 55) to a
depth of approximately two complete turns.
9 Connect the saw to a power source and turn on
the saw.
10 With the saw running, turn each set screw (item
55) - slowly and equally - until the saw starts to
slow down (there may be a change in pitch of the
motor).
It is very important that the set screws
are drawn down equally. Failure to do so can re-
sult in misalignment of gears.
11 Back off each set screw in equal amounts until
the full speed of the saw is reached.
12 Turn off the saw and disconnect it from the pow-
er source.
13
Check to see that there is very little back lash be-
tween the bevel and the pinion gears.
If there
seems to be too much backlash, back off set
screws (items 55) and repeat steps 7-13.
14 Assemble the remainder of the saw.
maintenance instructions
