JAROLIFT TDRR-01W, Оригинальное руководство пользователя

Страница: 15 / 60

15
ASSEMBLY
mounting the radio receiver
Observe the connection diagram on page 6.
function overview
• The mains connection of the radio receiver and all work on electrical installations may only be carried out by an authorised
electrician in accordance with the connection diagrams in this manual. by an authorised electrician in accordance with the
connection diagrams in this manual.
• Carry out all installation and connection work in a de-energised state.
1. Drücken Sie das Netzteil aus dem inneren Tragrahmen und dem
Außenrahmen. Halten Sie hierzu den Außenrahmen seitlich fest und
drücken Sie von hinten gegen das Netzteil.
2. Befestigen Sie zuerst den Tragrahmen in einer geeigneten
Unterputzdose.
3. Installieren Sie die Anschlüsse gemäß dem Anschlussplan in dieser
Anleitung.
Achten Sie beim Anschluss darauf, dass sich das Netzteil
bereits vor dem Anschluss auf dem Außenrahmen befinden
muss!
4. Drücken Sie nach erfolgtem Anschluss das Empfängermodul
(Netzteil) inklusive Außenrahmen in den zuvor installierten
Tragrahmen.
With the TDRR01W radio receiver button, you can turn a simple tubular motor into a convenient radio motor in no time at all.
The motor can then be operated remotely via all available Jarolift TDR radio transmitters.
In addition, the radio push-button offers a local operating option via the three large front keys (UP/STOP/DOWN).
The red LED control light on the front of the unit signals the following states:
• lights up permanently: (the unit is ready for operation)
(permanent lighting = orientation aid e.g. in the dark)
• flashes: (a move command is being processed)
• does not light up: (unit is in learning mode)
Please note!
When the end point of the tube motor has been reached, the LED continues to flash for about 4 min. as the receiver is still in
self-holding mode. Afterwards, the receiver automatically switches back to the ready-to-operate mode.
LED-Control lamp
Up
Stop
Down
Push the power pack out of the inner support frame and the
outer frame. To do this, hold the outer frame firmly at the side and
press against the power supply unit from behind.
First fix the support frame in a suitable flush-mounted box. flush-
mounted box.
Install the connections according to the wiring diagram in this
manual. .
When connecting, make sure that the power supply unit is
already on the outer frame before connecting it. must be!
After connecting, press the receiver module (power supply unit),
including the outer frame, into the previously installed support
frame.