3
8
Assemble Canopy Structures
A S S E M B L Y I N S T R U C T I O N S
Two-person team is recommended for assembly.
Internal Stem
1. Lay mast on soft clean surface. Remove bolt and nut from mast. Slide out internal stem
from bottom of mast and set aside.
Nut
2. Locate canopy structure and slider car
guide. Attach slider car guide to grooves on
back side of slider car assembly. Repeat
step for each canopy structure purchased.
Slider Car Guide
Slider Car
Assembly
3. From bottom of mast, insert slider car wheels onto 1 side of mast. Repeat for each
canopy structure purchased. NOTE: For P2 set up, insert slide cars onto 2 sides of mast
you wish to configure.
JCP501-P2
Configuration Options
Adjacent
Diagonal
Bolt
Crank
Mechanism
Crank
Mechanism
Slider Car
Wheels
Bottom of Mast
To Properly Fold Canopy
The 100% solution dyed canopies will last longer if you fold it as it was packed and shipped.
This technique is similar to the way a parachute is folded and is especially important when
folding each canopy for seasonal storage or when left in the closed position for an extended
period of time.
Using this technique at all times will significantly extend the life of the canopies.
1. When each canopy structure has been fully closed, stand in front
of the canopy structure and begin the folding process by pulling
out two panels opposite the mast.
2. Once rolled tight, pull adjacent panels out one at a time and fold to
the center, alternating sides until all the panels have been pulled
out from the arms and folded into the center.
3. Wrap tie on canopy around structure to secure. Repeat for each
canopy structure.
4. Wrap large provided strap around entire umbrella structure to secure together.
5. When not in use, cover entire umbrella structure with provided protective cover.
Protective Cover
Strap
