5
For Additional Support Call: 866.393.4202 or Email: [email protected]
18:
Check the cart square by placing a rafter square in the
bottom corner of the door frame or use the door as
a guide. Check that the gap around the door edges
to make sure that it is even and the door has smooth
operation. Fully tighten screws on the front and rear
sides of the cart.
19:
Secure the top of the cart using 4 nuts (C3).
20:
If the charging cables
were not
installed in step
8, install the cable management clips (G7, H8)
underneath each tray for later use.
See page 6 for
further instructions on cable clips.
Secure each tray
lid shut with one short screw with a silver washer (A1).
22:
Insert the metal device dividers into the trays.
See
page 8 for instructions on inserting the dividers.
21:
MD-5150 Model Only-
Locate the two screw holes
on the inside of the front door between the locking
hardware. With the swing handle in the open position,
align the hasp hardware with the two screw holes on
the front side of the handle. Insert the two included
screws from the inside of the door to secure.
Padlocks
are not included.
23:
To check that the charging system is properly
connected, plug the cart into a working outlet. The
Intelligent Charging System should make a brief
“beep” sound, the firmware version should display
in the LCD window, and a blue light will illuminate to
indicate the system is receiving power.
