Essential Charging Station
—
Owner’s Manual
Version F
Essential Charging Station
4
3
Assembling the Station
Prepare the Chassis
A. Remove contents of the carton and separate the
major components. Use the T25H Torx key that is
packaged with the manual to remove the security
screw and washer from the center of the tray lid
and set them aside to be replaced at the end of
assembly.
(AC stations only)
Remove the contents
from the tray.
B. Extend the sides of the chassis out at right angles
and tighten the pre-installed screws on corner of
each side. Each side has one on the top and one
on the bottom (4 screws total).
CS-1210 only:
The CS-1210 right panel is detached for shipping.
Attach with 2 [B2] screws and washers.
C. The supplied rubber feet [D4], [E5] can be
optionally installed in the four holes on the bottom
side of the station beside the holes used for
securing the station to a horizontal surface.
E
11.00
16.00
(14.00)
4X .391
4X .688
4X .50
(22.11)
(11.66)
16.33 CLEARANCE REQUIRED
14.72 CLEARANCE REQUIRED
(13.27)
CS-1610 WALL TEMPLATE
D
Aerial view of the
bottom of the chassis
A
C
B
Bottom view of the
assembled station
REVERSIBLE POWER STRIP
The power strip can be mounted on either the front or back side
by reversing the mounting brackets. Loosen the three screws
on each side, rotate the bracket, and replace the screws.
Position #1
Position #2
REVERSIBLE POWER STRIP
The power strip can be mounted on either the front or back side
by reversing the mounting brackets. Loosen the three screws
on each side, rotate the bracket, and replace the screws.
Position #1
Position #2
Position #1
Position #2
G
G
FF
11
33
55
22
44
Secure Chassis to a Wall or Desk (Optional)
D. If the station will be used on a table, desk, or
countertop, it may be optionally secured to the
surface by inserting 4 screws appropriate for
the surface type through the bottom side of the
chassis.
E. To mount the station to a wall, use the supplied
template as a guide for your screw location on the
wall. Other tools helpful to mounting include a
level, stud finder, and a pencil to mark mounting
points over studs in the wall.
WARNING: Failure to provide adequate structural strength for this
mounting system can result in serious personal injury or damage to
equipment. It is the installer’s responsibility to make sure the structure
to which this mounting system is attached can support five times the
combined weight of all equipment. Reinforce the structure as required
before installing. The wall to which the mount is being attached may have
a maximum drywall thickness of 5/8” (1.6cm). Always ensure that proper
hardware is used for the wall surface type. Never operate this mounting
system if it is damaged. Contact JAR Systems for replacement or repair.
Install the Power Strip
(AC stations only)
F. Install the power strip in one of the following
positions with [C3] 4 screws and nuts.
1. Recommended for smaller devices.
2. Recommended for most desktop usage.
3. Alternate position for desktop usage.
4. Recommended for most wall-mount usage.
5. Alternate position for wall-mount usage.
G. If necessary, the power strip can be mounted on
either the front (position #1) or back (position #2)
by reversing the mounting brackets. Loosen the
three screws on each side, rotate the bracket, and
replace the screws.
