200
Pole or Mast
Contacting range
of the clamp
Pole or Mast
Fixing belt
Clamp
Bending
Approx. 0.5mm
AIS Transponder
Covering tube
Pole or Mast
Clamp
Flathead screw driver
Protection sheet
Rubbers 10 x 10 x 10
AIS Transponder
Ground sheet
Covering tube
Fix the AIS Transponder
with the covering tube
Hexagon nut N8
Spring washer SW8
Washer W8
Tightening Torque
Caution: Do not tighten the belt with excessive torque.
Tighten the fixing belt with approx. 2.45Nm of torque, and
leave about 0.5mm of give in the belt when tested with
your fingers.
Fixing procedure
Note: Prepare the following parts:
1 washer W8
1 spring washer SW8
1 hexagon nut N8
(1) Stick Rubbers on the AIS Transponder.
(2) Attach with Protection sheet around the pole.
(3) Adjust the length of the ground sheet to fit the pole or
mast, bend it, and cut it off.
(4) Open the fitting belts with a flathead screwdriver.
(5) Wind the fitting belts around the pole or mast and the
AIS Transponder.
(6) Tighten the fixing belt with torque of approx. 2.45 Nm
with a screwdriver. (See figure below)
(7) Fix the ground sheet with a washer, spring washer,
Installation Procedure for
NTE-182 AIS Transponder
9
