Janz Tec emPC-CX+/C-1047UE, Руководство по оборудованию

Страница: 20 / 32

5 - 18 emPC-CX+ ( Hardware Manual )
•
Maintenance
©
Janz Tec AG Rev. 1.3
5.2 PCI Express Mini Card
NOTICE
The PCI express mini card must not be inserted or removed when power is applied to the
system.
After inserting the mini card into the connector, it must be push down and locked with two M2,5
screws.
NOTICE
•
The insertion depth of the screws that lock the PCI express mini card must not
exceed 3.2mm.
•
Make sure that the diameter of the screw or the washer does not make contact
with components or traces on the mini card. Some cards have components very
near to the mounting holes.
The PCI express mini card socket does not support mSATA modules or other SATA
based storage modules.
5.3 Installing PCI-Cards
The PCI/PCIe slot versions of the emPC-CX+ series allows the use of add-on cards.
When installing PCI cards, please consider that the card must support 5V
IO
signalling.
Additionally the amount of current the emPC-CX+ system can provide to the slots is
limited.
A large amount of current drawn by the PCI card usually leads to a large amount of heat dissipated
inside the housing. This causes the system to overheat and a damage of the systems is possible. If
high power PCI cards are used a system fan is recommended. Contact the Janz Tec AG for further
information. Before installing a PCI card, please make sure that the system is turned off. To get
access to the PCI slot, the top cover must be removed. If you use a system with a built-in hard disk
drive, please be careful when opening the housing because the hard disk drive is mounted on the
backside of the top cover.