Janser Master Mobile hydrauli, Инструкция пользователя

Страница: 8 / 20

Hydraulic Stripper
MASTER-MOBIL
OPERATING INSTRUCTIONS
8
4 SETUP
4.1 Hydraulic fluid
4.2 Speed control
When the machine is sitting in a normal operating position without
a blade, fluid should be ca. 2,5 cm (1") from the top of the tank.
Check fluid level if there has been a leak, damaged or ruptured
hose or a loose fitting.
Change the complete fluid once a year
4.1.1 Hydraulic fluid level
To add fluid, unscrew the filler port cap from top of the machine.
See figure 4.1 - A
To change fluid, remove the filler port cap. Remove drain plug
from side of machine.
See figure 4.1 - B
A container approximately ca. 5 litres in size will be needed to
drain fluid into.
Machine has a straining system, but add fluid through a
filter or funnel with a screen to keep fluid clean.
Speed control knob can be adjusted while the machine
is running
Turning speed control knob counter clockwise
will make the machine run faster.
Turning speed control knob clockwise
will make the machine run slower.
4.1.2 Adding or changing hydraulic fluid
FIGURE 4.1 A
FIGURE 4.1 B
Store Hydraulic Fluid in a dry, secured place!
Only use Hydraulic Oil or Compatible Fluid like IS032.
Non-compatible fluids could cause damage to unit or serious injury.