Janome QUILT MAKER PRO, Инструкция по эксплуатации

Страница: 46 / 56

Page 46
Quilt Maker Pro 18 User Manual
201704
Bobbin Winder Controls
All controls are shown in Figure 6.
Stop Button (Red)
The red button stops the bobbin winder once it has
started.
Start Button (Green)
The green button starts the bobbin winder. Press and
release the button to wind the bobbin. When the bobbin
is full the stop sensor will turn the machine off. If the
stop sensor is not correctly adjusted and has tripped
before the desired fill amount, pressing and holding the
green button down will continue to wind the bobbin until
the button is released.
Speed Selector
Rotate the speed selector knob to adjust the winding
speed. Winding speed can be adjusted while the bobbin
is winding.
Auto Fill LED Indicator
The LED is on when no bobbin or an empty or partially-
full bobbin is in the winder and it will flash while winding
a bobbin. When the stop sensor is tripped, the LED turns
off until the bobbin is removed from the winder.
Figure 6
Speed Selector
Auto Fill LED
Start (Green)
Stop (Red)
Stop Sensor
Using the Bobbin Winder
The Bobbin Winder is designed to wind bobbins for your
Janome Quilt Maker Pro 18 machine and will wind all
M-class bobbins. The bobbin winder includes a winding
speed control that allows winding bobbins at up to
3500 RPM.
1. Place the thread cone on the thread post to keep the
thread steady (Figure 7).
2. Place a bobbin on the bobbin post.
Tip: Make sure to push the bobbin all the way on the
post each time for consistent winding.
Figure 7