Janome QUILT MAKER PRO, Инструкция по эксплуатации

Страница: 14 / 56

Page 14
Quilt Maker Pro 18 User Manual
201704
Installing the Laser Stylus
Figure 11
To attach the laser stylus to the machine:
1. Locate the threaded hole on side of the machine
near the handwheel (see Figure 1, #12, page 7). The
laser stylus guide post comes with the washer and
nut on it. Remove the nut and washer, replace the
nut onto the post and then place the washer under
the nut and onto the machine painted surface. The
washer protects the painted surface when the nut
is tightened. Tighten the post clockwise until it is
securely in place. Use the nut to secure the post to the
machine.
2. Be sure the laser stylus is inserted into the laser
clamp.
3. Slide the laser clamp over the post to the desired
height.
4. Plug the laser power cord into the port on the rear
side of the machine. (see Figure 1, #13, page 7).
1. Find the two threaded holes located towards the front
of the upper machine arm. Attach the plastic thread
stand by placing two screws through the holes on the
side of the thread stand and attaching those screws
into the two threaded holes on the side of the upper
machine arm.
2. Remove the screw from the bottom of the thread mast
and place it in the thread stand socket on the front
corner of the thread stand. Secure the thread mast
by placing the removed screw through the underside
of the thread stand and into the bottom of the thread
mast.
Installing the Thread Mast
Figure 12