Janome memory craft 2400, Инструкция

Страница: 19 / 43

17
Changing Needles
z
Raise the needle by pressing the up/down needle
position key and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning it
counterclockwise.
x
Remove the needle from the clamp.
Insert the new needle into the needle clamp with the
flat side to the rear.
When inserting the needle into the clamp, push it up
as far as it will go and tighten the clamp screw firmly.
c
To find a good needle, put the flat side of the needle
onto something flat (a needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
q
Needle clamp screw
w
Pin
e
Needle clamp
To Remove and Attach Presser Foot
Press the red button on the back of the foot holder.
The presser foot will drop off. Place the selected presser
foot so the pin on the foot lies just under the groove of the
foot holder.
Lower the presser bar to lock the foot in place.
q
Red button
w
Groove
e
Pin
To Remove and Attach the Foot Holder
z
To Remove:
Remove the thumb screw by turning the screw
counter-clockwise with the screwdriver.
q
Thumb screw
x
To Attach:
Match the hole in foot holder with the threaded
hole in the presser bar.
Fit the thumb screw into the hole.
Tighten the screw by turning it clockwise.
w
Foot holder
e
Presser bar
x
z
q
e
q
w
e
w
z x
q
w
e
c