Janome MC 350E, Руководство по обслуживанию

Страница: 19 / 55

17
MC350E
Replacing Threader Plate and Adjustment
If the hook on the threader plate is damaged, replace it by following the instructions below.
To replace (Fig. 1):
1. Remove the presser foot.
2. Push down the Threader supporter plate to
remove from the Pin . (Fig. 1)
3. To attach the threader supporter plate, match the
groove of the Threader supporter plate with the
pin ,and then push it up to insert.
Threader supporter plate
Pin
Hook
Threader plate
Screw
Screw
Setting position plate
Adjusting threader plate position (Fig. 2):
1. When the Hook is slightly touching the needle
eye, loosen Screw and adjust the Threader plate
as shown.
If the hook position is too high or too low (Fig. 3):
1. Remove the face cover.
2. If the hook is too high, loosen the Screw and
lower the Setting position plate .
If the hook is too low, loosen Screw to slide up
the Setting position plate .
A
B
A
B
B
A
C
C
E
F
G
F
G
C
B
A
Fig. 1
If the hook on the threader plate is not aligned with needle eys, adjust it by following the
instructions below.
Fig. 2
(X)
E
D
View-X
Fig. 3
F
G
E
D
F
G
D