Janome M7050, Инструкция

Страница: 36 / 56

34
z
Use the same procedure as the square buttonhole
sewing. Set the stitch width to match the thickness of
the cord used.
With the buttonhole foot raised, hook the filler cord on
the spur at the back of the buttonhole foot. Bring the
ends toward you under the buttonhole foot, clearing
the front end.
Hook the filler cord into the forks on the front of the
buttonhole foot to hold them tight.
Lower the needle into the garment where the
buttonhole will start, and lower the foot.
q
Spur
w
Forks
x
Start the machine and sew the buttonhole.
Each side of the buttonhole and the bartacks will be
sewn over the cord.
Remove the fabric from the machine, and cut the
sewing threads only.
e
Needle thread
r
Bobbin thread
c
Pull the loose ends of the filler cord to tighten it.
Thread the each end of the cord through a hand-
sewing needle. Then draw the both ends to the wrong
side of the fabric and knot.
NOTE:
Cut the filler cord at both ends, if the filler cord is
stitched on the fabric and cannot be pulled.
z
x
c
q
w
e
r
Corded Buttonhole
q
Stitch pattern: 17
w
Thread tension dial: 1 to 4
e
Presser foot: Automatic buttonhole foot R 4
w e q