Janome Harmony 8100, Инструкция

Страница: 10 / 63

8
t
r
y
w
c
v
e
w
z
y
q
Winding the Bobbin
z
Lift up the spool pin. Place the spool of thread on
the spool pin with the thread coming off the spool as
shown.
Attach the large spool holder, and press it firmly
against the spool of thread.
* The small spool holder is used with narrow or
small spools of thread.
* To use the additional spool pin, guide the upper
thread as shown in
x
,
c
and then
v
.
x
Pass the thread under the thread guide.
c
Guide the thread around the thread guide.
v
Pass the thread through the thread guide.
b
Thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
n
Push the bobbin to the right.
m
With the free end of the thread held in your hand,
depress the foot control. Stop the machine when it
has made a few turns, and cut the thread close to the
hole in the bobbin.
,
Depress the foot control again. When the bobbin is
fully wound, it will stop automatically. Return the
bobbin winder to its original position by moving the
spindle to the left, and cut the thread as shown.
* The machine will not sew until the spindle is in
the left position.
q Spool pin w Spool e Spool holder
r Additional spool pin t Felt
y Additional spool pin hole
u
Bobbin winder spindle
x
b
u
q
w
n
m
,
¡
Removing the Bobbin
Slide the hook cover plate release button to the right,
and remove the cover plate.
q
Hook cover plate release button
w Hook cover plate