Janome CoverPro 3000, Инструкция, Страница: 17 / 49

14
Thread the looper in the following steps:
z
Draw the thread through the right side thread guide
from back to front as shown.
q
Thread guide bar
x
Slide the thread into the thread guide plate on the
machine as shown.
r
Thread guide plate
NOTE:
If the thread slips out from the thread guide notch,
pass the thread through the thread guide hole again
as shown.
w
Notch
e
Hole
v
Draw the thread down into looper thread guide (A).
u
Looper thread guide (A)
NOTE:
Hold the thread at both ends and tug gently to ensure
the thread is correctly inserted between the tension
disks.
c
Draw the thread along the slit and pass it through the
tension dial.
t
Tension dial
y
Tension disks
NOTE:
Pull the thread to pass it through looper thread guide
(A) until it locks in place while holding the thread at
the thread guide plate.
q
z
x
u
c v
t
y
r
w
e