Janome 7330 MAGNOLIA, Руководство по обслуживанию

Страница: 22 / 38

20
7330
Refer to the diagram for locating the connector posts to which each connectors should be connected.
NOTE:
TO DISCONNECT THE CONNECTORS:
1. Grasp the connector directly with your fingers and pull.
Do not pull the lead wire, as this may damage the contact sleeve inside the connector.
2. When disconnecting the machine socket and power transformer connectors, pull them while pushing them
toward the printed circuit board to unlock them.
NOTE:
TO CONNECT THE CONNECTORS:
1. Be sure that the color of each connector corresponds to the color of the connector post on the printed
circuit board (PCB) to which it is connected.
2. Position the connector correctly, then push it straight down until it locks in place.
CONNECTOR DIAGRAM
Slide volume
Printed circuit board "F"
Zigzag width motor
Feed motor
Lamp
Buttonhole
sensor
Upper shaft sensor
Machine socket
(Secondary)
DC motor
Power transformer
(Primary circuit)
Power transformer
(Secondary)
Machine plug
(Primary circuit)
Bobin winder switch