Janome 659, Руководство по обслуживанию

Страница: 17 / 25

FEED DOG HEIGHT
Lower the presser foot and turn the hand wheel toward you until the needle bar comes to the
highest point of its travel.
In this condition, the height of the feed dog above the needle plate should be 0.75 to 0.85 mm.
Adjustment procedure:
1. Set the stitch length dial at “4”, and lower the presser foot (H).
2. Turn the hand wheel until the feed dog (G) comes to its highest position.
3. Remove the bed cover (See page 4).
4. Loosen set screw (A) and nut (B).
5. Turn the adjusting screw (C) to set the feed dog height at 0.75 to 0.85 mm above the top
surface of the needle plate (D). Turn the adjusting screw (C) in the direction of:
(E) to increase the height.
(F) to decrease the height.
6. Tighten the nut (B).
7. Tighten screw (A) and attach the bed cover.
16