Janome 219S, Инструкция по эксплуатации

Страница: 22 / 30

20
q w e
r
t
z
c
x
q
Pattern selector:
w
Presser foot: Zigzag foot
e
Thread tension: 1–3
r
Stitch length: Any
t
Darning plate
Use the darning plate for button sewing. (see page 14.)
Sewing Buttons
Set the Pattern Selector at B (left needle position).
Mark the button placements on the fabric.
Position the darning plate onto the needle plate.
Place fabric under the foot.
Place the button under the foot aligning the left hole with
the needle point.
Lower the foot. Sew a few stitches to lock the
threads. Place a straight pin on top of the button in between
the holes.
(See illustration) When sewing over the button and straight
pin, a shank will be created.
Set the Pattern Selector at C. Select the zigzag width to
match the holes in the button.
Turn the balance wheel to confirm correct width. Sew sev-
eral stitches to secure the button to the
fabric.
Set the Pattern Selector at B. Sew several stitches to lock
the threads.
Cut the threads 20 cm (8˝) leaving a thread tail.
Bring the needle thread down through the button hole and
wind it around the thread shank.
Draw the thread to the wrong side and knot.