janitza 800-CT8-LP, Руководство пользователя и технические данные

Страница: 27 / 54

27
www.janitza.de 800-CT8-LP module
ESC
 
Duration
Confirm
Ok
30
Module position 1
Identify single module
Item Description
1
Flashing "orange" during operation and signaling
cyclic data exchange (Tx ... Transmit data, Rx ...
Receive data).
2
Lights up "green" when the power supply via the
JanBus interface of the basic device is correct, the
device is ready for operation (P ... Power).
3
Lights up "red" during initialization/startup and in
the event of a fault (error). Note in this regard Sect.
“15.2 Modules - Error cases” on p. 51.
LED status of the module in operation:
Tx
Rx
P
E
1
2
3
LED status of the module during module identifi-
cation:
Tx
Rx
P
E
1
2
4
3
Item Description
1
Blinks "orange" for the Duration of the module
identification.
2
Lights "orange" for the Duration of the module
identification.
3 Lights "green".
4 “Off”
INFORMATION
During the Duration of individual module iden-
tification , the blink intervals of all other modules
connected to the basic device are paused!
7.3.2 Entry Identify one module
·In the Diagnostics window, use buttons 2 “
5
” and
5 “
6
” to select the menu item Identify one module
and confirm with button 3 Enter .
·The Identify one module window appears.
·In the Identify one module window, use keys 2 “
5
”
and 5 “
6
” to select the menu item Module position
and confirm with key 3 Enter .
·The entry Module position blinks.
·Use the keys 2 "
5
" and 5 "
6
" to enter the position
number of the module to be identified (the position
number depends on the number of modules con-
nected in series to the basic device).
·Confirm the entry with key 3 Enter .
·Use keys 1 ESC and key 5 "
6
" to access the entry
Duration .
·Press button 3 Enter.
·The first digit of the entry Duration blinks.
·Use buttons 4 (

) and 6 (

) to change the position
of the digit to be set and buttons 2 (
5
) and 5 (
6
) to
change the digit (-1/+1).
·Confirm your entries with key 3 Enter .
·Use keys 1 ESC and key 5 "
6
" to access the entry
Confirm .
·Press button 3 Enter.
·In the entry Confirm , OK blinks.
·Pressing button 3 Enter starts the module iden-
tification with a blink interval of the LEDs on the
corresponding module (see Sect. “7.3.3 Module
identification - LED blink interval” on p. 27).
Fig. Window: Identify one module
Position of the module in
the order of the basic de-
vice’s module topology.
Time in s that the module
identification takes
(setting range 0-600 s)
Starts the module
identification
(LEDs blink)
7.3.3 Module identification - LED blink interval
The module identification (diagnostics) procedure
started on the basic device triggers a blink interval
of the LEDs on the current measuring modules. The
blink interval of the functions
Identify one module
and Identify all modules works the same way for a
single module or for all modules!