JANE Nurse Swing, Инструкция по эксплуатации, Страница: 26 / 56

26
sWING
GB
* The support leg (1) is safely positioned on the floor of the car and the support leg indicator (10) displays
the green signal.
For orthopaedic and safety reasons, newborn babies and babies that cannot yet sit up unaided (up to
about 1 year old), should always travel in the flattest reclining position, and in the rear facing position.
REMOVING THE INSERT FOR NEWBORN BABIES
The pre-fitted insert for newborn babies (21) is designed for babies to travel comfortably lying down and
is suitable for use with small babies.
The insert for newborn babies can be removed when the baby measures 61 cm (approximately 3 months)
to provide more space.
To remove the insert for newborn babies, simply unfasten the press studs on the headrest cover. First
remove the headrest cover and then remove the insert. Then, replace the headrest cover and the
shoulder straps and, lastly, fasten the press studs again.
Before washing the insert for newborn babies, remove the inner foam through the slots designed for
this purpose. The foam can be put back in through the slots after washing and drying the insert for
newborn babies.
REMOVING THE COVER
Removal
The cover has 7 parts fastened to the seat frame using a hook and loop, elastic edges, press studs and
straps. Once all the fastenings have been undone, the parts can be taken off for washing.
Follow the steps below:
* Unfasten the buckle of the 5-point harness.
* Unfasten all the press studs of the pads and parts of the cover.
* Take the shoulder pads off the straps.
* Take all the pads off the harness.
Pass the shoulder straps through the cover.
* To put the cover back on the seat, follow the same steps in reverse.
NOTE! When putting the shoulder strap pads back on, it is essential to make sure that:
* The closed edge of the pad is facing the child’s neck.
* The pads are correctly fitted onto the straps.
* The shoulder straps go through the pads.
WARNING! The cover is an integral part of the safety design of the seat. Therefore, the safety seat
should never be used without the cover.
CLEANING
It is important to use the original seat cover as it is essential to the performance of the safety seat. You
can get replacement covers from your retailer.
NOTE! Wash the cover before using it for the first time. The seat cover can be machine washed at a
maximum temperature of 30 °C and on a delicate wash. If you wash the cover at a higher temperature,
the fabric may lose its colour. Wash the cover separately and never tumble dry it. Do not dry the cover in
direct sunlight. The plastic parts can be cleaned with mild detergent and warm water.
WARNING! Do not use chemical detergents or bleaching agents under any circumstances.
WARNING! The integrated harness system cannot be taken off the safety seat. Do not remove any parts
of the harness. The harness system can be cleaned with mild detergent and warm water.
13
14