Zodiac Pool Systems, Inc.
2620 Commerce Way, Vista, CA 92081
1.800.822.7933 | www.ZodiacPoolSystems.com
ZODIAC
®
is a registered trademark of Zodiac International, S.A.S.U., used under license.
All trademarks referenced herein are the property of their respective owners.
©2012 Zodiac Pool Systems, Inc. H0294700 Rev C 1207
Page 4
Jandy
®
Pro Series, LXi Maintain Heat Relay
|
Installation Kit Instructions
C.
Testing the Maintain Heat Operation
1.
Replace the front panel (door).
2.
Turn on the gas supply at the heater.
3.
Test the heater/pump operation by running them.
Make sure that all of the pool heaters’s functions
are working properly.
D.
Replacement Kit List
The following table is for your reference. To order
additional parts, please contact your local distributor.
Parts List for Maintain Heat Relay Kit
Description
Qty
Maintain Heat Relay
1
Wire, Yellow (ground)
1
Wire, Orange
1
Screw #10-5/8"
2
Instructions
1
3. Pool Mode - Maintain Heat
If connected, the Maintain Heat mode allows the heater
to monitor the temperature of the water 24 hours a day
by turning the pool pump on and sampling the water
temperature. When the water temperature drops below
the programmed temperature set point, the control will
start the heater.
To operate in pool mode with the Maintain Heat feature,
press
POOL
, then press
MENU
, press the
Down
button
until
MAINTAIN POOL HEAT
is displayed, press the
MENU
button.
The associated left green LED indicator will light and
the unit will display
SET:XXX°.
Change the temperature
set point by pressing the
Up
or
Down
button until the
desired set point is displayed. After five (5) seconds of
inactivity, the new set point is stored in memory.
4. Spa Mode - Maintain Heat
If connected, the Maintain Heat mode allows the heater
to monitor the temperature of the water 24 hours a day.
When the water temperature drops below the
programmed temperature set point, the control will start
the heater.
To operate in spa mode with the Maintain Heat feature,
press
SPA
, then press
MENU
, press the
Down
button
until
MAINTAIN SPA HEAT
is displayed, press the
MENU
button. The associated left green LED indicator
will light and the unit will display
SET:XXX°.
Change
the temperature set point by pressing the
Up
or
Down
button until the desired set point is displayed. After five
(5) seconds of inactivity, the new set point is stored in
memory.
