Jandy AquaPure APURE1400, Инструкция по установке и эксплуатации

Страница: 35 / 40

Page 35
7.2 Service Codes
Code Number Possible Cause Corrective Action
120 Low current in forward direction to Cell 1. Clean cell if necessary (see pages 27 and 28)
2. Check DC Cord.
121 Low current in reverse direction to Cell 1. Clean cell if necessary (see pages 27 and 28)
2. Check DC Cord.
123 Extremely Low current to Cell 1. Clean or replace cell if necessary
(see pages 27 and 28)
2. Check DC Cord.
124 Higher than normal Current to Cell Contact a pool professional.
125 Cell needs to be cleaned Clean cell if necessary (see pages 27 and 28).
126 Low current in forward direction and VAC input voltage
below 100/200 VAC Contact a pool professional.
127 Low current in reverse direction and VAC input voltage
below 100/200 VAC Contact a pool professional.
144 Low Salinity (below 2.0 gpl) Add salt to pool to achieve 3.0 gpl (see pages 17
through 20).
145 High Salinity (above 4.0 gpl) Backwash fi lter if a DE fi lter is installed. Partially
drain pool and dilute with fresh water until salinity
returns to 3.0 to 3.5 gpl.
170 Possible Front board service condition or unit not
correctly wired to 120 VAC Contact an authorized service representative.
171 Possible Backboard service condition Contact an authorized service representative.
172 Flow Sensor service condition or fl ow sensor is
unplugged Contact an authorized service representative.
173 Low VAC input voltage and on board power supply is
not regulated or unit not correctly wired. Unit wired to improper AC voltage. Contact a pool
professional.
174 Pool Temperature is too high for operation of AquaPure Flow/ Salinity Sensor indicates water temperature at
sensor above 108 F. Reduce water temperature.
175 Flow Sensor air lock condition or very low salinity Verify proper Flow/Temp/Salinity Sensor installation
(see page 12 Figure 8). Check salinity with Myron
“L” meter calibrated for NaCl or test strips. Add salt
as necessary (see pages 17 through 20).
7.3 Additional Letter Codes
Code Condition Reason
EC External Control ORP unit or external controller has shut off chlorine
production.
Lo Low Temperature Cutoff Temperature of Pool is < 50 Deg. F. Chlorine
production stopped.
bo Boost In “Boost” mode unit will operate at 100%
production for 24 run time hours.
HH High-High Input has exceeded Maximum Range.
JA AquaLink RS Online AquaLink RS is controlling the AquaPure and
desired output percentages.
Jb Boost (AquaLink RS Interface) AquaLink RS is controlling the AquaPure and
“Boost” is active.