Page 22
4.5
Optional Remote Controls
Electrical wiring must be in accordance with all
applicable national and local codes and ordinances.
4.5.1
Connection to a Remote Pool-Off-
Spa Selector (3-Wire Connection)
4.5.1.1 Install the Remote Pool-Off-Spa
Selector
1.
Turn off the power to both the pool/spa control
system and the heat pump unit.
2.
Remove the 4 screws that attach the service/access
panel to the heat pump unit and the cover to the
junction box (see Figure 15).
3.
Run the wires from the pool/spa control system
into the conduit connection labeled “Low Voltage
Connection”, located on the lower right hand side
of the heat pump (see Figure 15).
4.
Connect the wiring from the pool/spa control
system to the heat pump remote control terminal
(see Figure 16a).
5.
Restore power to the heat pump and the pool/spa
control system.
4.5.1.2 Confi gure the Control Panel
1.
Make sure the control is in the
OFF
mode.
2.
To enter the Service Setup mode, press and hold
the
MENU
,
POOL
, and
SPA
buttons for 5
seconds.
NOTE The display will revert back to OFF after one
minute since the last key press.
Figure 16a.
Remote Pool-Off-Spa Connection
(3-Wire
Connection)
Figure 16b.
AquaLink RS or Remote TSTAT
Connection (2-Wire Connection)
3.
Press the Up or Down button to display
REMOTE
. Press the
MENU
button. The
SELECT REMOTE OFF
(default remote)
appears, use the Up or Down button to scroll
through the Remote options. When you reach
HI-LO-COM
, press the
MENU
button to select the
remote. Press
POOL
or
SPA
to exit the Service
Setup mode.
4.5.2
Connection to an AquaLink RS
Control System or Remote TSTAT
(2-Wire Connection)
4.5.2.1 Confi gure the AquaLink RS Control
System
1. Install
a
fi xed resistor, with a value of 2.2K Ohms,
in the solar sensor terminals #3 and #4 of the
green, 10-pin terminal bar of the AquaLink RS
Power Center (see Figure 17).
2.
Run the wires from the Heat Pump control panel
through the wiring conduit located on the outer
right hand side of the Heat Pump.
3.
In the AquaLink Power Center, connect the Heat
Pump to a standard relay, then connect the relay
to the solar pump output on the PCB. Set the time
to 11:59 PM; at 12:00 AM, the AquaLink RS
will auto-relabel Solar as Heat Pump. Otherwise,
the AquaLink RS will auto-relabel Solar as Heat
Pump within 24 hours.
4.
The Solar Button will activate the heat pump/
chiller and the Pool and/or Spa Heater Buttons will
activate the gas heater. In this manner the pool or
spa can be heated or chilled by the heat pump, the
gas heater or both.
