Jands USB Console Setup Guide Version 2.0
Copyright & disclaimer
This product is approved for use in Europe and Australia/New Zealand and conforms to
EN55103-1, EN55103-2, and EN60950. Conformance has been achieved for intended usage in
environment E1: Residential.
To ensure continued compliance with EMC Directive 89/336 and the Australian
Radiocommunications Act 1992, use only high quality data cables with continuous shield, and
connectors with conductive back shells. Examples of such DMX cable is Belden 8102 (100%
Aluminium foil screen, 65% Copper braid)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not properly installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
reorient or relocate the receiving antenna;
•
increase the separation between the equipment and receiver;
•
connect the equipment into an outlet on a different circuit from that to which the receiver is
connected;
•
consult the dealer or an experienced radio/television technician for help.
Disclaimer
Information contained in this manual is subject to change without notice and does not represent
a commitment on the part of the vendor. Jands Pty Limited shall not be liable for any loss or
damage whatsoever arising from the use of information or any error contained in this manual.
It is recommended that all service and repairs on this product be carried out by Jands Pty
Limited or its authorised service agents. Jands Pty Limited cannot accept any liability
whatsoever for any loss or damage caused by service, maintenance or repair by unauthorised
personnel, or by use other than that intended by the manufacturer.
Jands lighting products must only be used for the purpose they were intended by the
manufacturer and in conjunction with the user manual. Disconnect mains power when not in
use.
JANDS Pty Limited ACN 001 187 837
Locked Bag 15
40 Kent Rd
MASCOT NSW 1460
MASCOT NSW 2020
Sydney AUSTRALIA
Sydney AUSTRALIA
Phone: +61-2-9582-0909
http://www.jands.com
Fax:
+61-2-9582-0999
http://www.jandsvista.com
Copyright JANDS PTY LIMITED 2012 All rights reserved
Содержание Vista M1
Страница 1: ...Control Surface Setup Guide ...
