Instructions for use - SaltDome ultrasonic salt therapy device
Use
1.
Place the appliance on a horizontal, stable and dry surface where
it will be used (bedside table) and lift off the top cover.
Fig. 1
(FIG1)
Do not place a tablecloth or other textile under the appliance as
it may block the air vent.
2.
Plug the power adapter into the socket at the bottom of the device.
Figure 2 (FIG2)
3.
Use the measuring cup provided and fill 1-3 glasses of water into the
water tank (up to 300 ml)
Figure 3 (FIG3)
4.
Then dissolve 1/2 scoop of rock salt (NOT MORE!) in the 4th measuring
cup of water. Pour this salt solution into the water tank, which will
then fill. The water level should not exceed the Max level.
Figure 5
(Fig5)
If the water column is too high, the ultrasonic cell will not be able to
produce humidity, so the tank will not run out of water.
5.
It is normal to see dirt at the bottom of the tank after the salt has
dissolved. Rock salt is natural and unrefined. It is not dangerous for
you!
NEVER fill water into an appliance that is already on!
If tap water is hard or contains chlorine, use softened or bottled water.
Figure 4 (FIG4)
6.
Dissolving ½ spoon of rock salt is usually sufficient. For severe
complaints, the amount of salt may be increased slightly, but should
not exceed one scoop for the whole tank. More salt is not necessary
for therapeutic effect, but rather increase the time spent in the salty
air!
7.
Wipe the water tank dry with a paper towel. Replace the top lid
8.
Plug the power plug into the wall socket.
Figure 6 (FIG6)
9.
Press the POWER button to switch on.
Figure 9 (FIG9)
The appliance will only switch on if there is water in the tank. The "1
hour" LED indicating the on state will light up and the unit will start to operate.
The microscopic salt particles are discharged from the device through the top opening.
At most a slight mist is visible, and this is normal! Only very little vapour is emitted from the device.
10.
Press the POWER button again to set the timer. The time can be set to 1 hour, 3 hours, 6 hours. After the
set time, the device will automatically switch off. Press the
POWER button again to turn the LED light to ON. In this position, the appliance will run continuously and
will only stop when the tank is empty. Press
the POWER button again to switch off the appliance.
11.
A/M (Low/High Vapour Output) - use the A/M button to decrease/increase the amount of vapour
output. The change is hardly noticeable to the naked eye. The difference in vapour output between the
two modes is about 20-25%.
Figure
8
(FIG8)
12.
LIGHT - pressing the button turns on the LED built into the device and it changes colour continuously
every few seconds. If you like a colour, press the button again to set it to permanent. Press the LIGHT
button again to move through the colours. Finally, the light can be switched off.
Figure 7 (FIG7)
