J&R MANUFACTURING 700E, Руководство по эксплуатации и обслуживанию

Страница: 20 / 59

(e) Leave the racks in place and fill the pit with a hot water/oven
cleaner solution up to the middle of the exit flue opening. Heat the
pit up to 250° and allow the racks to revolve. Continue for at least
4 hours, drain and rinse the pit thoroughly.
Drain the washings from the pit through the drain valve (see Figure 1). If a
floor drain is not adjacent to the drain valve, attach a hose or pipe to the valve
and extend it
over to a suitable drain.
PLEASE NOTE
Methods (a), (b), and (c) are operable only if pit is cleaned every week. If several
weeks pass between cleanings, the cleaner will not penetrate and remove the
residue.
PREVENTIVE MAINTENANCE CHECK LIST
EVERY 45 DAYS
B
EARINGS
: Remove the access cover below the front oven doors. The rotisserie
bearings have lubrication extensions that terminate with grease fittings located
near the motor starter enclosure. Use a high temperature grease (Lubri-Plate
930-2 is recommended) and a cartridge-type automotive grease gun.
NOTE:
Low-temperature grease will harden at high temperatures and damage the
bearings.
C
HAIN
: Lubricate the chain with the same high temperature grease. Open the
front access door below the pit doors to access the chain. Check the chain
tension and adjust as necessary.
E
XIT
F
LUE
C
LEANING
: Clean this flue thoroughly from inside the cooking
compartment or remove the rear access cover adjacent to the flue and clean it
from the rear of the pit with the flue damper open.
NOTE: If this flue is not kept clean, the solids accumulation will corrode the
flue and/or retard the passage of smoke from the oven to the stack, causing
soot and/or temperature control problems.
EVERY 6 MONTHS
1. Inspect and repair as needed all gaskets. This includes the front door
gaskets, the two bypass gaskets, and the exit flue gasket.
2.
Inspect and adjust, repair, or replace the front door latch.
3.
Check the temperature control mechanism for proper operation. Cycle
the thermostat and make sure the combustion air damper and exit flue
damper are opening and closing (tightly). Lubricate all linkages at the
rear of the pit. Remove the thermostat faceplate and spray the moving
parts with a spray lubricant.
12