7. Plug in the J&M amplifier adapter cable # 1 to the
factory wiring harness amplifier plug and then connect
the corresponding plugs to the amplifier, including the
main power harness cable and secure all wires into
place using the zip ties provided.
(Photos-C)
8. Remove the 3 plastic retainer plugs holding the fabric cover over
the Harley amplifier in the back of the left side saddlebag.
9. Unplug the amplifier from the in-saddlebag wiring harness,
remove the two top mounting screws and lift the amplifier out of the
saddlebag bracket assembly.
10. Using a wide putty-knife like tool, slide the blade behind the amp
bracket to unstick the backing tape from the inside of the saddlebag
to remove the bracket.
(Photo-D)
Photo C
Photo D
11. Clean the rear inside of the saddlebag well with a
cleaner like Windex and let dry.
12. Then peel the backing from the adhesive tape
off the back of the J&M ROKKER amplifier/mounting
bracket assembly, and slide down into position and
secure by pressing into place.
(Photos-E)
Photo E
13. Then connect J&M amplifier adapter cable #2 to
the corresponding plugs on the amplifier and secure all
wires into place using the zip-ties provided.
(Photos-F)
Photo F
