22
1/2” x 5” Hex Bolt
1/2” Hex Nut
1/4” Centerlock Hex Nut
1/4” Washer
1/4” x 1” Hex Bolt
• Light Bar
Install the light bar. Secure the light bar using (4)
1/2” x 5” hex bolts and (4) 1/2” hex nuts.
Tighten hardware once installed.
Install the SMV sign. Secure using (2) 1/4” x 1” hex
bolts, (2) 1/4” washers, and (2) 1/4” centerlock hex
nuts.
Tighten hardware once installed.
Adjust the light bar loosening the adjustment
handle and moving the right portion of the light
bar. Tighten the adjustment handle once in desired
position.
1) Run the short harness, starting with the 4
way flat connectors go through the light bar
starting on the side nearest to the rear axle.
Facing the light bar from the front, the wire
will need to be run from left to right through
the channel on the outside of the light bar.
Connect the 4 way flat connector to the 4
way flat connector coming out of the left
hand light. Now run whats remaining of the
short harness to the right side through the
inside of the main tube on the light bar.
L/H
R/H
Start Here
Long Harness
Short Harness
2) Connect the 3 way flat connector that is coming off of the short harness to the 3 way flat connection coming out of
the light enhancer.
3) Connect the light enhancer to the long harness with the two 4 way square connectors.
4) Run the 3 male 1 female flat connector to the front of the top bar. Run the end of the connector through the top bar.
There is a hole for the wire to come out of the bottom of the top bar near the front of the wagon. Now run it through
the front axle, starting at the bottom rear left hand side to the middle front hole. Next go down the tongue, to the cord
wrap. For transportation connect the 4 way flat connector to the vehicle and wrap the remaining cord around the cord
wrap.
Adjustment Handle
Set Up Assembly
