J&M 525, Руководство по установке

Страница: 7 / 29

7
Rear Endcap Support Brace
Install the endcap brace . The purpose of the endcap brace is to hold the inside of the endcap up approximately 1” higher than the
outside of the endcap . Drill a hole using a 1/4” drill bit first followed by a 7/16” drill bit . The hole should be placed onto the nearest
crossbrace which is welded to the shell body . The hole should be located somewhere between the middle of the endcap and the
inside of the endcap . To accomodate for height adjustment, two braces will be used to support the endcap . Use the combination
that raises the inside lip of the endcap 1” above the outside edge of the endcap . Use 3/8” x 1” serrated flange hex bolts and nuts to
attach the braces to the grain cart .
1”
Inside Outside