J&M 525, Руководство по установке

Страница: 13 / 29

13
Installing the Roll Tarp Stops
Push down on the 1-1/4” square roll tube on both ends and in the center to fully extend the canvas . Line the roll tube cable spool up
with the spring return cable . Drill a 1/4” hole through the first stiffening patch . Fasten the canvas tarp using a pop rivet . Go to the rear
of the cart, pull the canvas tarp tight, and repeat the process . Then install pop rivets at the remaining stiffening patches . Once finished
slip the spring return cable loop over the cable spool .
Next place the 1” tube under the top bolt of the back corner bracket on the auger side . Drill a 1/4” hole through the tube and side-
wall approximately 18” to 24” in from the corner of the cart . Then re-drill the hole with a 7/16” bit . Place a 3/8” x 2” bolt through the
roll tarp stop, 1” square tie-down tube, and grain cart sidewall . Fasten with a 3/8” serrated flange nut . Now repeat this process at
the front of the cart . For the center hole slightly lift the 1” square tie-down tube approximately 1” higher than the two other holes .
Repeat the process to drill a 7/16” hole . Place a 3/8” x 2” bolt through the roll tarp stop, 1” square tie-down tube, and grain cart
sidewall and fasten with a 3/8” serrated flange nut .
NOTE: For grain carts that have a center splice make sure that the 1” tube is above the top bolt of the center splice.
18”-24”
Installing Pop Rivets on Roll Tube