Thank you for the confidence you have shown in J&M Corporation by
purchasing one of our innovative products.
If you have any question or comments about this product, you may
contact us at USA 1-520-624-7000 Monday thru Friday, 8:00AM thru
5:00PM Mountain Standard Time.
1415 S. Cherry Avenue
Tucson, AZ 85713 U.S.A.
Tel (800) 358-0881
Website: http://www.jmcorp.com
E-mail: [email protected]
9. Remove the stock grill from the inner fairing by removing the 3
attachment screws.
VERY IMPORTANT:
Discard these screws as
they will not be used again.
(Figure D)
10. Install the new ‘J&M grills using the (3) #12 X ½” countersunk
self-tapping screws provided, with the grill-mounted tweeter in the
upright position.
VERY IMPORTANT:
Do Not use the stock Harley
screws to attach the new ‘J&M grills, or the speaker pods will not
reinstall properly.
11. Install the new 6.71” ROKKER XXR speaker using the original
speaker attachment screws; Ensure that the speaker is placed
into the pod with the tweeter-wire exiting to the upper, outer cor-
ner.
(Figure E)
12. Plug the tweeter wire from the main speaker into the correspond-
ing plug on the backside of the grill. Then re-install the speaker
pod assembly back into the fairing, paying close attention to pull
the EXTRA tweeter wire length back out between the back side of
the grill and front of the main speaker, so that this extra wire does
not rattle against the main speaker cone when playing.
13. Repeat steps 2 through 12 for the opposite side speaker.
Important Note: If the bike is equipped with the Harley CB radio
module, ensure that the CB module is removed before removing
the applicable speaker pod assembly.
14. Test each speaker for proper operation before reassembling the
fairing.
Fig. D
Fig. C
Remove screws
Remove screws
Fig. E
