JAMO D 590, Руководство пользователя

Страница: 9 / 9

4
Maintenance
All Jamo loudspeakers are manufactured using modern,
thoroughly tested materials which usually require no other
maintenance than vacuuming or wiping using a soft, dry cloth.
If the loudspeakers have become greasy, clean them using a
cloth moistened with water or possibly a mild detergent.
Note:
Never use scouring powders, benzine, spirit or other
solvents to clean the loudspeakers.
The scope of the warranty
The warranty period will come into force as from the purchase
date stated on the invoice. The warranty will apply for the
following period of time:
• 2 years for electronics (power supply, amplifier, etc.)
• 7 years for other parts (cabinet, speaker units, etc.)
In case of warranty inquiries, please contact your dealer.
In case of request for service under warranty, please enclose your
original receipt.
Defects covered by the warranty:
Except for the defects stated below, the warranty covers any
production and material defects of the product.
Defects not covered by the warranty:
• Defects arising from accidents, misuse, normal wear and tear,
mis-maintenance, voltage variation, overloading, stroke of
lightning, and other force majeure events
• Defects arising from incorrect installation or operation
• Defects arising from modification/repair/attempt of repair by
a non-authorised service centre
• Defects arising from the use of non-original spare parts
• Defects on products with altered or lacking series number
• Other defects due to conditions or circumstances beyond the
supplier’s control
Transportation costs for servicing are not covered by the
warranty.
The supplier is liable only to repair or replace defective parts or
products. A replacement cannot exceed the value of the product
under warranty.
GB
Always make sure that:
The speakers are in correct phase;
The speaker’s + terminal is connected to the amplifier’s + terminal.
The speaker’s – terminal is connected to the amplifier’s – terminal.
Usually, the loudspeaker cable is marked on one wire which is normally used to connect the + terminals to ensure correct phase.
SINGLE WIRING
If you want to connect each loudspeaker with one cable, the “bridges” provided must remain
mounted between the two terminal sets. The loudspeaker is supplied from Jamo with the
“bridges” mounted for single wiring.
BI-WIRING
If bi-wiring is used, the “bridges” between the two terminal sets will have to be removed.
At the amplifier, the cables may be joined in one set of output terminals, or, if the amplifier has
two sets of output terminals, you may connect one cable to terminal set “A” and the other
cable to terminal set “B”.
Finally, you may also use two power amplifiers (bi-amping). Please contact your Jamo dealer
for further information.