7
OPERATION INSTRUCTIONS
4
5
Using the HEATER function.
Press the “TC” button to start the built-in heater.
The left-side red indicator on the control panel will illuminate.
The fluid will heat to a maximum of 65 degrees C.
To start the cleaning process press the ON button
(as described in point 3).
If required, you can press the OFF button at any time to stop
or pause the cleaning process. Press the ON button again to
resume cleaning and continue the countdown. You can press the
SET button at any time to reset the program.
When cleaning is finished, unplug the mains cable from the
mains outlet and from the unit. Then open the lid to remove
the item(s).
Pour away the water via the back, avoiding the ventilation slots
/ power inlet on the sides and control panel on the front face.
Wipe the stainless steel tank with a clean dry cloth.
4
This Ultrasonic Cleaner has built in circuit protection to avoid overheating.
If the overheat protection activates then the right-side red indicator will illuminate and the
unit will cease to operate. After approximately 15 minutes, after allowing the unit cool
down, press the ON button to resume operation.
5
Emptying the tank
• Remember to change the water between cycles as it becomes dirty.
• Always ensure the unit is unplugged when changing the water.
• Always pour liquid away via the rear channels, avoiding the ventilation slots / power inlet on the sides
and control panel on the front face.