Jam TWS Exec, Инструкция

Страница: 4 / 51

EN 4
CONNECT 1 EARBUD
Use the left or the right earbud independently. This is
a great option if you want to hear your surroundings
as well as your music.
STEP 1 – TURNING ON THE EARBUD
Your earbud will automatically turn on when taken out
of the portable charging case. If you need to turn it on
manually, you can press and hold the touch sensor for
5 seconds on the earbud.
STEP 3 – CONNECTING TO A DEVICE
Enable Bluetooth
®
on your device. From the
Bluetooth
®
menu, select “JAM TWS Exec”. When the
device and TWS Exec are connected, you will hear
a tone and the LEDs on the earbuds will slow flash
blue. This means the pairing is complete.
To disconnect from all connected device and reset
pairing, place both earbuds in the charging case and
quickly tap the touch sensors on both earbuds 3
times, at the same time. The LEDs will flash purple
3 times. Your earbuds are now disconnected from
the previously connected device and will need to be
paired again before using.
STEP 2 – PAIRING MODE
Once a single earbud is taken out of the case or
manually turned on, it should enter into pairing mode.
The LED will flash red and blue and you will hear
a series of tones. This will indicate your earbud is
in pairing mode. If it does not enter pairing mode
automatically, place the earbud back in the charging
case for 2 seconds and then remove it again to enter
pairing mode.
STEP 3 – CONNECTING TO A DEVICE
Enable Bluetooth
®
on your device. From the
Bluetooth
®
menu, select “JAM TWS Exec”.
When the device and TWS Exec are connected, you
will hear a tone and LED will slow flash blue.
This means the pairing is complete.
To turn off your earbuds, place your earbuds back in
your case, or press and hold the touch sensors on
both earbuds for 5 seconds. We recommend keeping
your earbuds in the charging case when not in use.
TURNING OFF YOUR EARBUDS
long-press 5s
long-press 5s
or
Bluetooth
®
Devices
JAM TWS Exec
Bluetooth
®
Devices
JAM TWS Exec