JAI GO-5101M-PMCL, Руководство пользователя

Страница: 25 / 60

— 25 —
GO-5101M-PMCL / GO-5101C-PMCL
Valid Input/Output Combinations
The following signals can be used as sources for each output destination (Trigger Selector, Line
Selector, Pulse Generator Selector).
You can also connect two different sources to NAND paths in the GPIO and reuse the signal generated
there as a source for a different selector.
The combinations of source signals and output destinations are indicated in the following.
Selector
(Cross point
switch output)
Source signal
(Cross point
switch input)
Output destination
Trigger
Selector
Line Selector
Pulse
Generator
Selector
Frame Star
t
Line1 Output Sour
ce
Nand Gate 0 In 1 Nand Gate 0 In 2 Nand Gate 1 In 1 Nand Gate 1 In 2
Pulse Generator
Clear Sour
ce
Signals to use as output
LOW
      
HIGH
      
Software

× × × × × ×
Line 4 TTL In
      
Line 7 CC1
      
Pulse Generator 0
     
×
User Output 0
      
User Output 1
      
NAND 0 Out
 
× ×
  
NAND 1 Out
   
× ×

Exposure Active ×
     
Frame Active
×
     
Frame Trigger Wait ×
     
FVAL ×
     
LVAL
× × × × × ×

Trigger
Source
Line Source
Pulse
Generator
Clear Source
Use
: Indicates default values for each selector. “Factory default values” (page 17) shows the
default values for [Frame Start].
Camera Output Formats
The GO-5101-PMCL supports a variety of output formats.
The following tap geometries are supported.
The settings on the frame grabber board must be configured to match the tap geometry setting on the
camera. For details configuring frame grabber board settings, refer to the operating instructions for
each board.
Tap Geometry CL Configuration Video Process Bypass Off Video Process Bypass On
1X2-1Y Base bit: 8/10 bit: 8/10/12
1X3-1Y Base bit: 8 bit: 8
1X3-1Y Medium bit: 10 bit: 10/12
1X4-1Y Medium bit: 8/10 bit: 8/10/12