Jäger ADwin, Руководство по установке

Страница: 40 / 69

ADwin-light-16 system with USB interface
ADwin
36
ADwin Installation, manual version 2.1, December 2005
The default setting for the power supply is: +5 Volt on pins 1a, 1b, 1c and
ground (GND) on pins 32a, 32b, 32c. (see also the pin assignment in the
hardware manual).
If you need a different pin assignment, please call our sales department.
Please pay attention to the voltage drop from the power supply unit up
to the VG edge connector of the board. Please make sure that the pins
have e5 Volt and that there are no interferences at the power
supply.
– Connect the power supply with the VG edge connector.
– Connect the ADwin board via USB cable with the PC.
To ensure USB communication be as failure-free as possible, we recommend
to establish a low-impedance (short, very thick) ground connection between
PC-casing and the
ADwin USB-device.
The ground connection may also – contrary to the inept USB cable – equalize
existing differences in potential very well.
Installation of the power adapter for L16-EXT
In order to avoid damages to your PC, the installation has to be made in an
environment without any electro-static discharges.
– Close Windows, shut down the PC and remove the power supply cable.
– Open the PC according to the manufacturer’s instructions.
– Remove an unused slot metal sheet and install the power adapter.
Connect the power adapter’s cable with a free connector of the internal
power supply cable of the PC power supply unit.
– Close the PC enclosure and connect the power supply cable.
– Connect the power supply cable of the L16-EXT system to the power
adapter.
– The L16-EXT system is not connected to earth via power adapter! Con-
nect the GND socket with the central earth connection point of your
device and pay attention to corresponding notes in your hardware man-
ual.
– Connect the PC and L16-EXT with the USB cable. Power up your PC.
To ensure USB communication be as failure-free as possible, we recommend
to establish a low-impedance (short, very thick) ground connection between
PC-casing and the
ADwin USB-device.
The ground connection may also – contrary to the inept USB cable – equalize
existing differences in potential very well.
6.2 Installation of the drivers
Start your PC.
The operating systems Windows 9x, ME, 2000 and XP recognize the new
hardware and start the device manager in order to install the drivers. If the
operating system does not react, restart Windows.
Driver installation from
standard directory Windows looks for the best driver (default) and asks for a source directory. With
standard installation starting from the
ADwin CDROM version 3.00.2300, enter
<C:\ADwin>
(else
<C:\ADbasic3>
with older versions). Confirm your input
with „
Next
“.