Jaga HEDW.094040, Инструкция по установке и эксплуатации

Страница: 87 / 96

15.2.2. Setting the power
To have a controller adapted to the towel rails and estimate the energy consumed, it is ess ential to
set the power of the device.
3. Pre set value: 300W. Select a value between 300W and 1500W by pressing or .
4. To save and automatically move to the next setting, press .
To save the Expert settings, press three times.
15.2.3. Restoring factory settings
If the PIN code protection is disabled, the User, Installer and Expert settings are re-initialized. From
the Power setting, press
.
5. ‘Rest’ appears on the display, press .
6. ‘NO’ appears. Press or to select ‘YES’.
- YES: factory settings reset
- NO: factory settings not reset
7. Press for 5 seconds. The device returns to its initial configuration and goes back automati-
cally to the home display of the Auto mode.
Press three times to exit the Expert settings.
16. POWER CUT / BACKUP
– After short power cuts (less than 3 hrs), the device will start up again without any outside input
being required. All the settings and the correct time will be saved.
– For longer power supply cuts (more than 3 hrs), check the timer setting. All the other settings are
automatically and permanently saved.
5 sec
87
EN