63
EN
JAGA NV | BRIZA RAD 055/041 | MANUAL | 5 JULI 2021, 14:29 | V.01
6. SETTINGS VIA CIRCUIT BOARD CONTROLLER
6.1. ADJUSTING THE WATER TEMPERATURE
The unit starts from the set temperature
/
.
6.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster .
1. Start setup mode: hold the [
-
] button until
the
blue LED
flashes 5x and release .
2.
3. Exit setup mode: hold the [
-
] button until
the
blue LED
flashes 5x and release .
6.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster .
When using a heat pump, it may be necessary to set the water temperature at a lower setting .
1. Exit setup mode: hold the [
+
] button until
the red LED
flashes 5x and release .
2.
12 ̊C
14 ̊C
16 ̊C
18 ̊C
20 ̊C
22 ̊C
24 ̊C
26 ̊C
The blue LED flashes quickly
as soon as
the minimum temperature is reached.
The blue LED flashes quickly
as soon as the
minimum temperature is reached.
The red LED flashes quickly
as soon as t
he
maximum temperature is reached.
The red LED flashes quickly
as soon as th
e
maximum temperature is reached.
Automatic control: The
green LED
lights up when the water temperature (supply water) is lower than the
set temperature .
Automatic control:
The green LED
lights when the water temperature (supply water) exceeds the set
temperature .
Briefly press the [-] or [+] button to adjust the set
temperature .
Briefly press the [-] or [+] button to adjust the set
temperature .
24 ̊C
26 ̊C
28 ̊C
30 ̊C
32 ̊C
34 ̊C
36 ̊C
38 ̊C
3. Exit setup mode: hold the [
+
] button until
the red LED
flashes 5x and release .
The device returns to the selected mode (30sec).
1
-
1
-
1
-
1
-
18
28
